Skip to Content.
Sympa Menu

opal - AW: [Opal] Neighboring bunches

opal AT

Subject: The OPAL Discussion Forum

List archive

AW: [Opal] Neighboring bunches

Chronological Thread 
  • From: "Frey Matthias (PSI)" <matthias.frey AT>
  • To: "Adelmann Andreas (PSI)" <andreas.adelmann AT>
  • Cc: "Winklehner Daniel (PSI)" <daniel.winklehner AT>, Jianjun Yang <psiyang AT>, "opal AT" <Opal AT>
  • Subject: AW: [Opal] Neighboring bunches
  • Date: Tue, 24 Jan 2017 14:10:07 +0000
  • Accept-language: de-DE, de-CH, en-US

Hi all again

I did a provisional fix in my local copy of OPAL. The saveOneBunch was not
called if MBMODE=FORCE. Leading to a problem when copying the initial
distribution for injection of the next bunch.


Von: Frey Matthias (PSI)
Gesendet: Dienstag, 24. Januar 2017 14:04
An: Adelmann Andreas (PSI)
Cc: Winklehner Daniel (PSI); Jianjun Yang; opal AT
Betreff: AW: Neighboring bunches

Hi all

I could run a simple Multibunch simulation using 2 bunches and MBMODE=AUTO.
However, the simulation with MBMODE=FORCE is broken since the particle number
of the next bunch is not set properly.


Von: Adelmann Andreas (PSI)
Gesendet: Dienstag, 24. Januar 2017 08:43
An: Frey Matthias (PSI)
Cc: Winklehner Daniel (PSI); Jianjun Yang; opal AT
Betreff: Neighboring bunches

Hi Matthias,

on the TrackCmd command enter for example NNB=2 & TrackRun MBMODE=FORCE

This forces 2 bunches from the beginning of the simulation.

@Daniel & Jianjun: the neighboring bunch mode seams to be broken. Matthias
needs to get that
back on line for his PhD thesis so help is appreciated.

Thanks Andreas

Archive powered by MHonArc 2.6.19.

Top of Page