The OPAL Discussion Forum

[Jonathan Edelen <jedelen AT radiasoft.net>]

Hi Christof,

That will be good to keep in mind. Nicole's suggestion was exactly what I needed.

Thanks!

Jon

On Mon, Feb 19, 2018 at 12:29 PM, Christof Metzger-Kraus <christof.j.kraus AT gmail.com> wrote:

Hi Jon,

do you use version 1.9 of opal? Then you could, instead of APVETO, add an error to the lag using DLAG. If you set APVETO and change LAG then possibly the design trajectory changes. In contrary DLAG doesn't change the design trajectory. Unfortunately this feature doesn't seem to be documented yet

Christof

Am 19.02.2018 4:47 nachm. schrieb "Jonathan Edelen" <jedelen AT radiasoft.net>:

Hi Andreas,

I would like to run a simulation with autophasing on, then take the results of the autophase algorithm and re-run the simulation with autophasing off. Then perform perturbation studies on upstream cavities with downstream cavities at a constant absolute phase.

Jon

On Mon, Feb 19, 2018 at 3:30 AM, Adelmann Andreas (PSI) <andreas.adelmann AT psi.ch> wrote:

Hi Jon, use APVETO (https://gitlab.psi.ch/OPAL/src/wikis/Manual/elements) 

to flag the cavity (ies).

Cheers Andreas 

------
Dr. sc. math. Andreas (Andy) Adelmann
Staff Scientist

Paul Scherrer Institut WBBA/219 CH-5232 Villigen PSI
Phone Office: xx41 56 310 42 33 Fax: xx41 56 310 31 91
Phone Home: xx41 62 891 91 44
-------------------------------------------------------
Friday: ETH CAB F37 or HPK G 28   +41 44 632 75 22
============================================
The more exotic, the more abstract the knowledge, 
the more profound will be its consequences.
Leon Lederman 
============================================

On 19 Feb 2018, at 05:58, Adelmann Andreas (PSI) <andreas.adelmann AT psi.ch> wrote:

Begin forwarded message:

From: Jonathan Edelen <jedelen AT radiasoft.net>
Date: 19 February 2018 at 03:20:51 CET
To: Andreas Adelmann <andreas.adelmann AT psi.ch>
Subject: Running Opal without Autophase

Hi Andreas,

I am trying to make some comparisons between OPAL and measurements taken at Fermilab and I would like to run opal without autophasing to mimic the physics in the machine when we scan the phase of the gun relative to other cavities. Is there a way to export the results of the autophase routine and then use those results directly with autophasing off? This would hopefully give me the initial cavity phases from tune up and then I can vary the gun phase from there.

Best

Jon