Skip to Content.
Sympa Menu

opal - Re: [Opal] init.opal - sample file and instructions

opal AT

Subject: The OPAL Discussion Forum

List archive

Re: [Opal] init.opal - sample file and instructions

Chronological Thread 
  • From: Dragos Constantin <Dragos.Constantin AT>
  • To: Christof Metzger-Kraus <christof.j.kraus AT>
  • Cc: opal <opal AT>
  • Subject: Re: [Opal] init.opal - sample file and instructions
  • Date: Thu, 25 Apr 2019 09:23:48 +0000
  • Accept-language: en-US
  • Authentication-results: spf=none (sender IP is ) smtp.mailfrom=Dragos.Constantin AT;
  • Authentication-results: localhost; dmarc=pass

Hi Christof,
I’ve spent 10 minutes looking through the source code folders and I could not find a stand alone init.opal file, and I realised I had to look deeper inside the code, which is what you did.

I will ask Andreas to include a small section about this issue in the documentation with a simple example.

Best regards,
From: Christof Metzger-Kraus <christof.j.kraus AT>
Sent: Wednesday, April 24, 2019 10:48:06 PM
To: Dragos Constantin
Cc: opal
Subject: Re: [Opal] init.opal - sample file and instructions
Hi Dragos,

I have to admit that I had to look for this information in the source code: all commands of OPAL can be used in the init.opal file. I've just tried it out and it seems to work fine.


On Thu, Apr 25, 2019 at 1:17 AM Dragos Constantin <dragos.constantin AT> wrote:
Dear Colleagues,
I managed to install opal 2.0 on my RHEL 7.0 workstation. As part of the final
setup I wanted to setup an "init.opal" file in my home folder, but I could not
find any information in the documentation or any init.opal example file.

Where can I find more information about init.opal and what environment
variables can be set inside this file?


Archive powered by MHonArc 2.6.19.

Top of Page