Skip to Content.
Sympa Menu

opal - Re: [Opal] RBend reference particle trajectory properties

opal AT lists.psi.ch

Subject: The OPAL Discussion Forum

List archive

Re: [Opal] RBend reference particle trajectory properties


Chronological Thread  
  • From: Christof Metzger-Kraus <christof.j.kraus AT gmail.com>
  • To: "Li, Zhi" <zql810 AT mail.usask.ca>
  • Cc: "opal AT lists.psi.ch" <opal AT lists.psi.ch>, "Boland, Mark" <mark.boland AT usask.ca>
  • Subject: Re: [Opal] RBend reference particle trajectory properties
  • Date: Tue, 24 Nov 2020 20:11:35 +0100
  • Authentication-results: localhost; iprev=pass (mail-il1-f169.google.com) smtp.remote-ip=209.85.166.169; spf=pass smtp.mailfrom=gmail.com; dkim=pass header.d=gmail.com header.s=20161025 header.a=rsa-sha256; dmarc=pass header.from=gmail.com

Hi Zhi,

if you add
OPTION, LOGBENDTRAJECTORY=TRUE;
to your input file then you should find a file in the directory 'data' containing the trajectory of the reference particle.

Best regards,
Christof

On Tue, Nov 24, 2020 at 7:00 PM Li, Zhi <zql810 AT mail.usask.ca> wrote:
Hello OPAL-Team,

I'm currently learning to add a RBend component in OPAL-T. 
The input file is a modified version of the example RFphotoinjector.in file. 


I added the following to the input file (from the OPAL manual):

Bend: RBend, ANGLE = 30.0 * Pi / 180.0,
FMAPFN = "1DPROFILE1-DEFAULT",
ELEMEDGE = 0.25,
DESIGNENERGY = 10.0,
L = 0.5,
GAP = 0.02;

After the simulation finish running, I don't see any output describing the reference trajectory properties. I was expecting this information to be written in the (.out) file.

Please let me know where this information is stored. Thanks!

Best regards,

Zhi



Archive powered by MHonArc 2.6.19.

Top of Page