The OPAL Discussion Forum

[Christof Metzger-Kraus <christof.j.kraus AT gmail.com>]

Hi Zhi,

did you try to increase the verbosity of the output (--info 2 or higher on the command line)?

Best regards,

Christof

On Tue, Nov 24, 2020 at 8:45 PM Li, Zhi <zql810 AT mail.usask.ca> wrote:

Hi Christof, 

After adding the line

OPTION, LOGBENDTRAJECTORY=TRUE;

I do get the trajectory file. 

However, I also want to see the trajectory properties output like the picture below.  

How do I get the code to write this information on the (.out) file?

Best regards, 

Zhi

---

From: Christof Metzger-Kraus <christof.j.kraus AT gmail.com>
Sent: November 24, 2020 1:11 PM
To: Li, Zhi <zql810 AT mail.usask.ca>
Cc: opal AT lists.psi.ch <opal AT lists.psi.ch>; Boland, Mark <mark.boland AT usask.ca>
Subject: Re: [Opal] RBend reference particle trajectory properties

 

CAUTION: External to USask. Verify sender and use caution with links and attachments. Forward suspicious emails to phishing AT usask.ca

Hi Zhi,

if you add

OPTION, LOGBENDTRAJECTORY=TRUE;

to your input file then you should find a file in the directory 'data' containing the trajectory of the reference particle.

Best regards,

Christof

On Tue, Nov 24, 2020 at 7:00 PM Li, Zhi <zql810 AT mail.usask.ca> wrote:

Hello OPAL-Team,

I'm currently learning to add a RBend component in OPAL-T. 

The input file is a modified version of the example RFphotoinjector.in file. 

https://gitlab.psi.ch/OPAL/src/-/wikis/RFPhotoInjector

I added the following to the input file (from the OPAL manual):

Bend: RBend, ANGLE = 30.0 * Pi / 180.0,

FMAPFN = "1DPROFILE1-DEFAULT",

ELEMEDGE = 0.25,

DESIGNENERGY = 10.0,

L = 0.5,

GAP = 0.02;

After the simulation finish running, I don't see any output describing the reference trajectory properties. I was expecting this information to be written in the (.out) file.

Please let me know where this information is stored. Thanks!

Best regards,

Zhi